modelling

Comfort conditions in a warm/hot environment can be achieved by means of several cooling strategies ranging from the obvious sun shading to the less obvious radiant cooling. These strategies are identified and three selected computer models are evaluated in terms of their capability to cope with them. The result is that the most popular or sophisticated computer models available are not able to deal with passive cooling. Also the problem of is the interface between currently available computer models and their final users, the architects, is analyzed.

The application of computer tools in construction is set for a revolution as integrated software packages come close to fruition. But there are barriers to the increased use of electronic design tools, notably worries over validation, the skills needed both in the design studio and on site and the quality assurance issues of correctly defining product elements and the design criteria. Over the next three articles, we examine the potential for using integrated computer design tools.

The authors' previous analysis of dynamic insulation is extended to include the inner and outer air film resistances with the objective of modelling the variation in surface temperature with air flow. The boundary condition that comes closest to predicting the variation of the surface temperature with air flow is one which assumes that the conduction heat flux at the wall surface, rather than the net heat flux, is equal to the flux incident on the wall from global environmental temperature, T.;.

A new thermal simulation model, QUICK II, is presented and numerous verification case studies performed on naturally ventilated buildings are discussed. Four new case studies performed on two buildings located in the Negev desert in Israel are discussed in detail. All the measurements pertaining to these new case studies were taken independently by the Desert Architecture Unit of the Jacob Blaustein Institute for Desert Research. These measurements are provided, along with a description of the buildings.

Occupant-controlled heating, ventilating and air conditioning (HVAC) systems allow inhabitants of open-plan spaces some degree of control over their immediate microclimate. Typically, cooled air is supplied at floor or desktop levels. The amount and direction of air flow is under occupant control. Productivity increases have been attributed to this form of control. This paper proposes a simplified model of the thermal environment created by an occupant-controlled HV AC system and the behavior of the occupants within it.