simulation

One of essential problems of the present research related to building analyses is air flows determination. Air flows not only cause energy consumption but also influence air quality parameters, specially in a multizone (and high) buildings. Thepaper presents the main assumptions of the newly developed simulation method. The major departures are addressed which distinguish this alternative method from other multizone models.These include the principles of dividing a dwelling house into zones and the accomplishment of the simulation.

The equivalent leakage area algorithm is used to illustrate the use of statistical simulations to predict distributions of infiltration and energy loss for buildings. The important parameters in the model are: leakage at 50 Pa pressurisation, indoor and outdoor temperature, leakage in the ceiling and the floor, wind speed, building height and shielding class. Most of these parameters are not known accurately. In the statistical method we assumed for each a distribution based on measurement or good guess.

The LESO building is a three storey, medium-sized office building on the campus of the Swiss Institute of Technology in Lausanne. In this building component leakages have been carefully determined followed by extensive measurements of the boundary conditions as well as the air flows. This paper first gives some basic concepts of the evaluation and the sensitivity analysis. Then, the measured data are compared with results from simulations performed with the COMIS multizone air flow program.

The paper presents a criterion to assess the performance of mechanical exhaust hoods for dome stic kitchens and a procedure to experimentally test them; an analysis of the relevant parameters which affect their performance is made, the test results are shown, and finally these are compared with the results of a numerical fluid dynamic code. Experiments were performed using the tracer gas technique, and attention has been drawn rather on the hood efficiency in the removal of pollutants than on the IAQ in the test room.

For thermal comfort and energy conservation reasons, displacement ventilation and radiative cooling systems are increasingly used. Simulation programs are generally not able to correctly simulate such systems because of their one node approach for the air temperature. A procedure for creating DOE-2 inputs to simulate both system types each alone or in combination - without program code change - was developed, based on a more detailed new TRNSYS-Type, and validated against existing experimental data sets.