LoginThe large heat loss from Passive-stack ventilation (PSV) systems quite often makes natural ventilation systems unattractive and it is therefore desirable to implement heat recovery in PSV stacks.
Bibliographic database Airbase
AIRBASE is the Bibliographic Database of the AIVC. It contains publications and abstracts of articles related to energy efficient ventilation. Where possible, sufficient detail is supplied in the bibliographic details for users to trace and order the material via their own libraries. Topics include: ventilation strategies, design and retrofit methods, calculation techniques, standards and regulations, measurement methods, indoor air quality and energy implications etc. Entries are based on articles and reports published in journals, internal publications and research reports, produced both by university departments and by building research institutions throughout the world. AIRBASE has grown and evolved over many years (1979 to present day, over 22000 references and 16000 documents available online). For most of the references, the full document is also available online.
Access to the publications is free of charge.
This paper reports on the findings of a research exercise that has aimed to crystallise the current state of the Indoor Air Quality debate across a broad spectrum of the industry.
This paper gives an account of a project to test the effectiveness of simple passive strategies to improve thermal comfort in Government Primary Schools in Pakistan ..
The present Government has a target for reduction of the UK's carbon dioxide emissions of 20% of 1990 levels by the year 2010, which is in fact greater than the legal commitment set at the Kyoto summit on climate change in December 1997.
This paper considers the numerical modeling of room airflows and illustrates the usefulness of computational fluid dynamics as a design tool for ventilation systems.
The procedure of incorporating duct leakage into the T-method simulates leakage as an additional parallel section with zero length for each duct section. The assumption that additional air leakage creates additional system resistance is wrong.
Explicit algebraic equations for calculation of wind and stack driven ventilation were developed by parametrically matching exact solutions to the flow equations for building envelopes.
This paper describes the development of software for simulating the air-conditioning environment in a computer room.
The rising stream around a human body attributable to metabolic heat can carry contaminants from the floor level to the human breathing system.
Measured contaminant and heat removal effectiveness data are presented and compared for a 3: 1 scale model room, which represents a smoking room, lounge, or bar with a two dimensional airflow pattern.
ASHRAE currently provides little practical information for optimizing the design of a cigar or smoking lounge, although recent ASHRAE forums have indicated an increased interest in this area.
Recent ASHRAE forums have revealed an increased interest in information and guidance relative to designing and applying ventilation systems for areas where smoking is permitted.
A small commercial building was monitored before and after energy-saving retrofits to study the impact of retrofits upon ventilation rates, humidity, building pressure, and air-conditioning energy use.
The goal of this work is to better understand the influence of window U-factor and solar heat gain coefficient on residential space heating and cooling energy use in the United States.
Many methods of estimating energy savings from measured weather-dependent energy consumption data attempt to compensate for varying weather conditions between the pre- and post-retrofit periods by identifying an empirical model of pre-retrofit ene
A three-dimensional computational fluid dynamics (CFD) analysis has been used to predict airflow patterns in laboratory fume hoods.
Current methods for designing exhaust stack height and exit velocity are based on avoiding contamination of the roof, walls, and nearby ground surface of the building on which the stack is located.