probe

A new simple method is proposed here for the experimental singling out of the air flow patterns in a room. It is based on the use of a series of thermofoil probes, arranged in a lattice, that can be suspended at the ceiling of the room under test.

The calibration and use of a shielded dual sensor hot-wire probe, originally developed at McGill University for velocity measurement in highly turbulent and reversing flows, is described. The new probe permits measurements to be made in flow conditions which are not amenable to conventional hot-wire techniques. Two conventional hot-wire anemometers are used to drive the probeand a simple electronic circuit is required to decode the signals and producea continuous voltage analogue of the velocity component in one dimension.

Wind pressures on three Navy buildings at the Kanehoe Marine Corp Air Station, Hawaii were measured. Indoor and outdoor variables were also measured including temperature, dry bulb, wet bulb, relative humidity, wind speed, and wind direction. Pressure measurements were carried out using Validyne DP103 pressure transducers, and a static pressure probe. Natural ventilation is estimated 1. by combining window areas and pressure coefficients with wind speed and 2. using the LBL infiltration model.

Describes methods of measuring the three-dimensional flow field using a three-sensor hot-wire probe, with emphasis on the techniques developed by the author's group at the Pennsylvania State University. The hot-wire equations, data processing procedure, calibration techniques, and a discussion of various errors in the measurement are included. Some typical data acquired by thisprobe is also included.

Describes a probe, developed for sensing static pressure in two-dimensional air flow. It was designed as a sensor for the measurement of static pressure acting on the surface of a building but the design also permits it to be used in free-stream flow. Gives details of the construction of the probe, calibration procedure and the effects of Reynolds number and of the sensitivity of the probe to pitch.

Describes a probe, developed to measure air flow which can be used to find the leakage profile of a window. Discusses measurement principle, accuracy of measurement and experimental method. Suggest use of the probe for locating leakage points andgiving quantitative data of the amount of leakage. A possible use is for testing windows that are already installed in buildings

Describes a photo-electric technique for instant determination of contaminant concentration in wind tunnel studies of stack gas dispersion. A roving sensor is used to measure the light scattered by the particles of oily aerosol representing theprototype stack effluent. The minature probe has a noise level of only one hundred thousandth of the full linear range of the output signal for a time constant of 5s. Device is also suitablefor measurement of fluctuating flow properties, such as turbulence, where a high frequency response is required.

Describes adaptation of photo-electrical optical technique to measure ventilation rates in wind tunnel models. Illustrates probe photographically and diagrammatically. It comprises essentially a light-emitting diode and a hybrid photodiode-amplifier detector. Compares technique with conventional tracer gas technique using helium and a katharometer and finds good agreement. Considers optical probe has considerable potential for measurements in small and multi-celled models where conventional techniques are not feasible.