English

Proposes a simple equation derived using a more complex theoretical model for use in the prediction of the infiltration performances of houses over a range of meteorological conditions. Initial comparisons have been made with the results from field measurements in a range of typical modern UK house types.

Briefly reviews the study of wind flow around buildings. Shows that fundamental theoretical and experimental studies are beginning to produce simple descriptive and mathematical models of flows round buildings. These should enable designers to predict the general features of wind around a proposed building or group of buildings at an early stage in the design. Gives some examples of these models.

The results of a prediction method for calculating ventilation rates in a detached house are compared with experimental measurements described in aprevious paper. The method is capable of giving good agreement for a wide range of ventilation conditions. The need is demonstrated for further work in two important areas - the spatial distribution of background areas and the effect of turbulence.

Derives analytical expressions for the exchange of air across doorways or similar apertures, in terms of the temperature difference between the spaces on both sides of the opening and the net volume of air flowing through this as a result of unbalanced air supply or extract.

Describes work sponsored by the Electric Power Research Institute (EPRI) to investigate indoor air quality in 10 single-family houses and 2 office buildings in Boston. The point was to compare indoor and outdoor pollutant levels, and find reasons for the differences. Found particulate levels were higher indoors, and houses with gas facilities showed higher concentrations of carbon monoxide and nitrogen oxides.

A combination of a wind-tunnel investigation and a mathematical simulation technique conducted on models of two-storey parking garage situated beneath alarge block of buildings (consisting of houses, shopping centre and offices) shows that wind penetrating the partly open garage facades can provide sufficient ventilation. Studies the effects on ventilation of varying the open area of the facades and of fitting openings in the garage roofs. Measures the effect of such ventilation means on air quality close to buildings.

Numerically predicts air quality and thermal comfort in 2-dimensional ventilated air spaces of several geometries when conditions on the various room surfaces are taken to be either adiabatic or constant temperature. 

Reviews methods of energy conservation in factories. States that excessive infiltration is unlikely to be the cause of high energy consumption, but that the most significant loads imposed by infiltration probably occur through open loading bays. Suggests the installment of double door lobbies to overcome this. Says the ideal factory heating system would include mechanical ventilation, with outside air mixed with warm "roof level" air. Describes potential sources of energy wastage and ways of rectifying this situation.

Gives instructions for weatherstripping and caulking houses, indicating which materials are best for different jobs, and comparing prices. Covers jamb weatherstripping for doors and windows, weatherstripping for door bottoms, sealing the joist and attic spaces, and sealing around window and door openings.

Defines types of condensation occurring in houses and describes practical ways for the householder to control surface and concealed condensation. Gives instructions to builders for installing air/vapour barriers to meet the required standards, and shows ways in which ventilation can control condensation.